Timer
The Taskloc timer — tracking time on a task without GPS or the location permission, starting and stopping, the forgotten timer reminder and the end time
Updated:
What it is
The timer tracks the time you work on a task without recording a GPS route. It is handy for office work or when GPS is unavailable.
How it differs from GPS tracking
| GPS tracking | Timer | |
|---|---|---|
| Records a route | Yes | No |
| Needs the location permission | Yes | No |
| Depends on the master "GPS tracking" toggle | Yes | No |
| Tracks time | Yes | Yes |
The timer does not depend on whether GPS tracking is turned on in the settings. A restriction in the team policy hides the Timer button.
Starting the timer
- Open the task card.
- Tap Timer (next to the Tracking button).
- The timer starts counting — a line with the time in
HH:MM:SSand a Stop button appears on the card.
The notification in the shade appears without a foreground GPS service — it is an ordinary notification with a chronometer and a Stop button.
Stopping the timer
- Tap Stop on the task card.
- Confirm in the stop sheet — the time is written to the tracker as a time entry.
The Stop button in the notification stops the timer right away, without the sheet: no comment and no task status change; the time is written the same way.
Forgotten timer reminder
When a timer reaches 4 hours of active time (paused time does not count), a "Timer is still running" notification arrives with the task and the active time:
- Continue — the timer keeps running; the next reminder comes no sooner than 2 hours later.
- Stop — opens the stop sheet.
The reminder never stops anything by itself — the decision is always yours. These notifications use the "Session reminders" channel.
End time
If a reminder has already fired for the timer, or the app has registered that you left the task site's geofence, the stop sheet shows an End time block:
- Now — the session ends at the moment you confirm.
- When the reminder came — HH:MM, N h MM min — the session ends at the first reminder.
- When you left the site, HH:MM (by geofence, ± a few minutes) — the session ends at the moment you left. For a timer the departure comes from the system geofence signal, so it is approximate.
What happens to the time
When the timer stops, the time is sent to the tracker as a time entry (the same as for a GPS session). Without a network, the entry is queued and sent automatically once the connection is back.
If the time tracking module is turned off for the project in the tracker, the entry does not go through there (for Redmine the app shows an error with a hint about the Time tracking module) — but the time is still saved in Taskloc (the Mileage section, the dashboard). See FAQ → Time is not written to the tracker.
The Routes section
Timer sessions are not shown in the Routes section (it only shows GPS tracks with coordinates).